If you want a strong, enduring yet affordable shower, tiling a shower with ceramic tile is the best option for you. A shower built in Ceramic tiles is very easy to clean.
Ceramic tiles will save your shower from the bites of humidity, dust mites and fungi. The ceramic tiles, specially the glazed ones assure you safety of waterproofing and protection from biological and chemical agents.
You have to indulge in a lot of labor for tiling a shower with ceramic tile. But your effort will pay off in huge profits with an excellent finish.
Tiling The Shower Walls
Tiling a shower with ceramic tile requires you to go about the job in a planned manner. The first step is all about laying the foundation for the shower walls. Backerboards, such as WonderBoard or Durock cement board, will be ideal for the walls. Being resistant to water, they will best meet the standards as base for installing ceramic tiles to high-moisture areas.
Backerboards can easily be installed directly on walls and fixed firmly to wall studs and ceiling beams with the help of hot-dipped galvanized nails or galvanized wood screws. Once the backerboards are well set, you need to cover all the joints with fiberglass mesh tape. Apply a coating of latex thin-set or an adhesive mortar before going ahead with installing the ceramic tiles.
Tiling The Shower Floor
To tile the shower floor, you need a pre-sloping of the floor. Apply a layer of mortar to the floor and structure a slope from the shower rim to the center of the floor which homes the shower drain. This will direct the flow of water towards the shower drain.
After the construction of the pre-slope plan for the installation of a shower pan membrane liner, which is a resilient plastic liner.
Place the membrane liner underneath the pane of tiles and mortars to steer the water that seeps through the floor grout to the shower drain beneath.
You will need to lay the pan membrane liner at the base of the shower area and secure it to the sides of the shower wall frame using nails. You will also need to cut out a slit in the membrane to slot in the adjustable shower drain assembly.
Now its time for you to arrange the floor backer boards. An ultimate coat of mortar will give it solidity. Now you will enter the last stage of tiling a shower with ceramic tile.
Carefully install the tiles maintaining level and scales. The design should be effectively centered. After the tiles are set and the grouting is restored, adjust the shower drain assemblage.
About The Author:
Easy
Kitchen Improvement Tips & Tricks, inmediately gaing the knowledge to make your home a better living space for YOUR Family & YOU. Loads of Home Improvement articles at "
Do It Yourself Tips"
This article is free for republishing
Article Source:
http://www.articlealley.com
